Hi. i have yaesu dx3000 and config on usb cat.
/usr/bin/rigctld -m 132 -r /dev/ttyUSB0 -t 4532 -s 38400 --set-conf=serial_handshake=Hardware --set-conf=rts_state=ON --set-conf=dtr_state=ON
everything work without CW !?
On CW settings i select hamlib but when i go to cw window and put cq the radio does not respond.
Is it possible for this to work?

Good Evening,

When I double click on a DX-Cluster spot, I get the wrong frequency if there is a mode change from CW to SSB and viceversa.

Let's make two examples:
-The pitch of my CW tone is set to 700Hz.

downloaded and it will not work!!can't remove, can't install ANY programs, the "remove" tab is useless!!! this program has really screwed up my system!!!

Hi!

I'm running cqrlog 2.4.0 (001) on Linux Mint 19.3. Database is a Mariadb on a remote FreeBSD server (Server version: 10.3.14-MariaDB FreeBSD Ports).

When running Statistics->DXCC Statistics->Rebuild DXCC-Statistics from the QSO-window the latest QSO table entry, fields "itu", "waz" and "cont" will get changed:

--------snipp-----------

This is an occasional issue, but I've just seen it change an entry where I end up with a duplicate contact entry and one which should be there gets deleted.

Luckily I'm uploading to HamQTH automatically at the moment and thus the Status of log upload window is open and the following showed up...

HamQTH: Uploading W6DF ... OK
HamQTH: Done ...
HamQTH: Deleting original W6DF ... OK
HamQTH: Uploading updated AE3RM
HamQTH: Already exists
HamQTH: Done ...