When i type a call in the new qso window, and press tab, call info gets looked up at QRZ.com.
At the lower right a call + name apears

Then when i double click the call to get it selected and type a different call and press tab, the new call info gets retrieved, but in the lower richt , the call and name of the new call gets added instead of "replaced"
When the new qrz info gets retrieved, this field is not cleared.
For as far as i remember, this used to be the case.

Hi
I have a problem. I have configured cqrlog to work with flrig and here everything works. Unfortunately when I give in cqrlog "remote for wsjtx" and wsjtx configure with flrig this one is not cooperating with working with two vfo. When I configure cqrlog to work with hamlib (Yaesu dx3000) and the same wsjtx there is again the same problem. Only when I run wsjtx alone and configure it to work with hamlib(dx3000) there is not this problem. Anyone encountered something like this?
System: OpenSUSE Tumbleweed

I am new to crqlog. It looks like it is exactly what I need for my logging needs.

I just installed crqlog 2.3.0-2 via apt on my old 32-bit PC running anti-X Linux.
(Anti-X 19 is based on Debian Buster).

The installation of cqrlog and all its dependencies was successful.

But when I try to open a new Database / Logfile, I see the following error:

"" is an invalid integer.
Press OK to ignore and risk data corruption.
Press Abort to kill the program"

I press OK and nothing happens.

After all the database and version problems I had in December, everything seems to be working fine. However, tonight I scrolled to the end of the QSO list and there are no QSOs shown prior to 2020-12-15. This was alarming!

I made sure there were no filters. I tried re-sorting the list. Same problem.

Then, in desperation I checked my ADIF backup files and all QSOs are there. Whew!

Then, in CQRlog I set up a filter for QSOs from 2016-01-01 to 2019-12-31 and the missing QSOs appeared in the list. I cleared the filter and they disappeared again.

I am puzzled that CQRLOG seems to stop at member #23907 when reading the skcc.txt member list and populating the NEW QSO award field with the member number. It works for member #23907, but does not work for any member I tested higher than that. At the moment, there are 23944 SKCC members. I loaded the skcc.txt file from the CQRLOG website on order to test it at numbers this high, but there are too few members in that file to repeat the test.