Cursor bug in RST sent field

4 posts / 0 new
Last post
dk7ob
Cursor bug in RST sent field

Hello,

I just installed cqrlog 2.2.0(001) on a fresh Kubuntu 18.04 and notice a small cursor bug which I didn't see on my old 16.04 install:

If I use the TAB key to go to the "RST sent" field in CW mode, cqrlog fills in a 599 with the S field highlighted. That's fine. But if I enter an S value, say "5", it updates the "T" field, so the report becomes 595 instead of the expected 559.

Anybody noticed this bug too?

Regards,
Wolf, DK7OB

ok2cqr
ok2cqr's picture
Re: Cursor bug in RST sent field

Hi Wolf,

yes, I know about this bug. Unfortunately it's happening only on specific configuration of GTK theme. It's alredy fixed in the source code on GitHub and it will be part of new release. I wrote my own code to rewrite the selected part of the report and it's independent on the GTK configuration.

73 Petr

dk7ob
Thanks Petr. I did not see

Thanks Petr. I did not see this bug on my old Kubuntu 16,04 (with same version of CQRLOG IIRC), so I'll check what the difference in the GTK configuration is.

Regards,
Wolf, DK7OB

dk7ob
Bug fixed, thank you!

The new version j2.3.0 ust came in. This bug is fixed, thank you very much!