CQRLOG - open discusion

TRX Control - TS450S very very long response time when change the band by TRX control

Submitted by dl4alb on

Hi,

after a few tries at last I get my TS450S running with TRX control, but if I try to change the band by click the band buttons in TRX control window it takes about 5 to 10 seconds (and sometimes nothing happens) till the transceiver changes the band.

Changes on the transceiver are updated in CQRLOG as fast as expected.

Any hints?

 

Another problem (or not?), when I start CQRLOG at command line I get this running output:

Forums: 

Problem with TRX Control on my TS-940

Submitted by k4ska on

Hello all - I have a TS-940 and cannot get the TRX to see my radio.  I am using an FTDI USB to RS232 device which worked fine under Windows so I know the device is good.
I am not sure what I put into the Device block in the TRX setup under Preferences.  I was going to use /dev/ttyUSBX (where X would be my USB port) but I am not sure which one it is.  
Here is the output from my "lsusb" command:  BTW I  am using Ubuntu 12.04(LTS)

Forums: 

TS-480 suddenly lost rig control

Submitted by aa2up on

I have lost rig control on my Kenwood TS-480-SAT. It was working fine after the upgrade to version 1.5.2--until yesterday. I am using Ubuntu 12.04, 64-bit.

My rig control still works fine with Fldigi, so I know it is not a problem with my serial port.

I have been using the same Cqrlog TRX Control settings for many months with no problems. But suddenly rig control is gone. I tried some other settings, but nothing works.

Please help!

Rich, TI7/AA2UP

This is what I get when I start Cqrlog from terminal:

Forums: 

Pages

Subscribe to RSS - CQRLOG - open discusion